Diagnostic Aids
- If a DTC P0452 is intermittent, road test the vehicle while observing the FTP sensor with a scan tool. A momentary reading of less than 0.2 volt may indicate an intermittent short to ground in the sensor input circuit.
- The EVAP system diagnostic can be monitored on the scan tool under the I/M System Information selection. When the EVAP test displays a YES status, indicating that the system diagnostic is completed, check for DTC P0452 in the Last Test Failed screen of the scan tool. If there is no DTC P0452 displayed the EVAP system diagnostic has run and passed, indicating that no malfunction was present this time. DTCs MUST be cleared in order to view the Current Status of the system diagnostics being performed. Do not forget that the I/M System Information tests only indicate that the test has run, not if the test passed or failed. The Last Test Failed screen must be checked for related DTCs in order to determine the outcome of the diagnostic test involved. Refer to Inspection/Maintenance Evaporative Emission System Set .
- An intermittent malfunction may be caused by a fault in the sensor electrical circuit. Inspect the wiring harness and the components for an intermittent condition. Refer to Intermittent Conditions .
- The information included in the Freeze Frame data can be useful in determining the vehicle operating conditions when the DTC first set.