FixVault
Home › Pontiac › 2007 › Wave Base, 4D Hatchback, D16/MLM › Repair and Diagnosis (Single Page) › Engine Performance › System › Engine Controls & Fuel - 1.6L - Introduction (2 Of 2) › Repair InstructionsEngine Control Module Replacement › Intake Air Temperature Sensor ReplacementRemoval Procedure › Removal ProcedureInstallation Procedure

Removal ProcedureInstallation Procedure

    Fig 1: Locating Intake Ducting To Engine
    GM1241530Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Disconnect the intake air temperature (IAT) sensor connector.
  3. Remove the IAT sensor by pulling it out of the air intake tube.
About FixVault