FixVault
Home › Pontiac › 2008 › G5 GT, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 2.4L - Introduction (2 Of 2) › Repair Instructions › Crankshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the CKP sensor O-ring seal with clean engine oil.
  2. Install the CKP sensor.
    NOTE: Refer to Fastener Notice .
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of CKP Sensor Wiring Harness Electrical Connector And CKP Sensor
    GM1656996Courtesy of GENERAL MOTORS CORP.
  4. Connect the CKP sensor wiring harness electrical connector to the CKP sensor.
  5. Install the starter. Refer to Starter Motor Replacement .
About FixVault