FixVault
Home › Pontiac › 2008 › G8 Base › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2) › Repair Instructions › Intake Manifold Runner Control Solenoid Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Intake Manifold Runner Control Solenoid To Manifold Retaining Bolts
    GM1949895Courtesy of GENERAL MOTORS CORP.
  1. Install the intake manifold runner control solenoid (1) to the manifold.
    2. NOTE: Refer to Fastener Notice .
  2. Install the intake manifold runner control solenoid to manifold retaining bolts (2) to intake manifold runner control solenoid.

    Tighten:  Tighten the intake manifold runner control solenoid bolts (2) to 10 N.m (89 lb in).

  3. Install the upper intake manifold. Refer to Lower Intake Manifold Replacement .
About FixVault