FixVault
Home › Pontiac › 2008 › G8 Base › Repair and Diagnosis › Restraints › Restraints Control Systems › Seat Belt System › Repair Instructions › Child Restraint Tether Anchor Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Child Seat Anchor Assembly
    GM2043543Courtesy of GENERAL MOTORS CORP.
  1. Install the child seat anchor assembly to the rear window shelf.
    2. Fig 2: Identifying Child Seat Anchor Assembly To Body Retaining Bolt
    GM2043542Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice .
    IMPORTANT: Ensure child restraint assembly is installed as per illustration, failure to adhere to this installation will result in incorrect operation of the child restraint assembly.
    IMPORTANT: Ensure that the anchor fitting is parallel to the vehicle centerline.
  2. Install the child seat anchor assembly to body retaining bolt (2).

    Tighten:  Tighten the bolt to 20 N.m (22 lb ft).

  3. Close the child seat anchor assembly cap (1).
About FixVault