FixVault
Home › Pontiac › 2008 › G8 GT › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 6.0L - Introduction (2 Of 2) › Repair Instructions › Ignition Coil Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Ignition Coil To Ignition Coil Assembly Retaining Bolts
    GM1950822Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Install the ignition coil to ignition coil assembly retaining bolts (1).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

    3. Fig 2: Identifying Ignition Coil To Ignition Coil Wiring Harness Connectors
    GM1950818Courtesy of GENERAL MOTORS CORP.
  3. Connect the ignition coil to ignition coil wiring harness connectors (1).
  4. Install the ignition coil assembly to the engine.
    5. Fig 3: Identifying Ignition Coil Assembly To Rocker Cover Retaining Bolts
    GM1950813Courtesy of GENERAL MOTORS CORP.
  5. Install the ignition coil assembly to rocker cover retaining bolts (2)

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  6. Connect the main ignition coil harness connector (1) to the ignition coil assembly.
    7. Fig 4: Identifying Spark Plug Wires
    GM1950809Courtesy of GENERAL MOTORS CORP.
  7. Connect the spark plug wires (1) to the ignition coils.
  8. Install the engine cover. Refer to Engine Cover Replacement .
  9. Connect the battery ground cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
About FixVault