FixVault
Home › Pontiac › 2008 › Grand Prix Base › Repair and Diagnosis › External Pages › Different car › Section 166 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Instrument Panel Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inflatable Restraint I/P Module
    GM929419Courtesy of GENERAL MOTORS CORP.
  1. Align the inflatable restraint I/P module to the I/P trim pad.
    2. NOTE: Refer to Fastener Notice .
  2. Install the inflatable restraint I/P module nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Route the PSIR wire harness under the locating rib and attach the metal edge clips to the I/P trim pad.
  4. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement .
    5. Fig 2: I/P Module Bracket Bolts
    GM1202160Courtesy of GENERAL MOTORS CORP.
  5. Install the inflatable restraint I/P module bracket bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  6. Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
About FixVault