Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Antenna Cable

Courtesy of GENERAL MOTORS CORP.

Insert the antenna cable (3) through the opening in the roof, make sure the 2 tabs (2) lock in.
Connect the antenna base cable assembly, to the rear antenna extension cable. Refer to Radio Antenna Cable Extension Cable Replacement .

Fig 2: View Of Antenna Cable Base

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Secure the antenna cable base (1) to the roof with the nut (4).
Tighten: Tighten the antenna base cable nut (4) to 4.5 N.m (40 lb in).

Fig 3: View Of Antenna Cable Assembly

Courtesy of GENERAL MOTORS CORP.

Route the antenna base cable assembly (1) along the roof (5).
Secure the antenna cable (1) to the roof (5) with the 4 retainers (4).
Install the headliner. Refer to Headlining Trim Panel Replacement .
Install the antenna mast. Refer to Fixed Antenna Mast Replacement .