FixVault
Home › Pontiac › 2008 › Grand Prix Base › Repair and Diagnosis › External Pages › Different car › Section 331 (Lighting Systems) › Repair Instructions › Tail Lamp Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Tail Lamp Components
    GM819965Courtesy of GENERAL MOTORS CORP.
  1. Install the following to the lamp sockets, if removed:
    • The stop lamp bulb (1)
    • The turn signal lamp bulb (6)
  2. Install the following to the tail lamp:
    • The stop lamp socket (2)
    • The turn signal lamp socket (5)
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the tail lamp (7) to the vehicle. Secure the tail lamp (7) with the 3 nuts (3).

    Tighten:  Tighten the tail lamp nuts to 10 N.m (89 lb in).

  4. Connect the tail lamp electrical connectors.
  5. Install the rear compartment trim panel (4) to the vehicle.
  6. Close the rear compartment lid.
About FixVault