Circuit/System Verification
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Program or configure the module that set DTC B1014. Refer to Control Module References
for the specific instructions.
- If the module will not configure, replace the module that set the DTC.
- With a scan tool, clear the DTC.
- Ignition OFF, remove the scan tool, open and close the drivers door.
- Wait 60 seconds, then recheck for DTCs.
- If DTC B1014 returns, replace the module.