FixVault
Home › Pontiac › 2008 › Solstice Base, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 2.4L - Introduction (2 Of 2) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Locating Fuel Tank Pressure Sensor
    GM1594372Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor (2).
    2. Fig 2: Locating Fuel Tank Electrical Connectors
    GM1594359Courtesy of GENERAL MOTORS CORP.
  2. Connect the fuel tank pressure sensor electrical connector (5).
    3. Fig 3: View Of Fuel Sending Unit Access Cover & Bolts
    GM1594369Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the fuel pump module access cover.
  4. Install the access cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Install the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
About FixVault