FixVault
Home › Pontiac › 2008 › Torrent Base, AWD › Repair and Diagnosis › Steering › Steering Wheel & Steering Column › Repair Instructions › Steering Column Jacket Replacement › Installation Procedure

Installation Procedure

  1. Clean the lower column shaft splines.
  2. Ensure the upper jacket shaft splines are clean and free of debris.
  3. Use the supplied grease to apply 2 grams (0.07 ounces) of grease to the column shaft splines.
  4. Ensure that the steering wheel alignment notch is in the 12 o'clock position.
    5. NOTE: Refer to Fastener Notice .
  5. Install the jacket to the column housing.

    Tighten:  Tighten the bolts to 11 N.m (97 lb in).

    6. Fig 1: View Of Steering Column & Attachment Bolts
    GM928844Courtesy of GENERAL MOTORS CORP.
  6. Install the upper column attachment bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  7. Install the left closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  8. Install the knee bolster. Refer to Knee Bolster Replacement .
  9. Install the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
  10. Install the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement 
  11. Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  12. Install the column trim covers. Refer to Steering Column Trim Covers Replacement .
  13. Install the steering wheel. Refer to Steering Wheel Replacement .
  14. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  15. Road test the vehicle to verify steering operation.
About FixVault