FixVault
Home › Pontiac › 2008 › Torrent Base, FWD › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 3.4L - Introduction (2 Of 2) › Repair Instructions › Secondary Fuel Tank Module Replacement › Installation Procedure

Installation Procedure

  1. If the fuel level sending unit is being replaced, install the fuel level sending unit into the new fuel pump. Refer to Fuel Level Sensor Replacement - Secondary .
    2. Fig 1: View Of Suction Port
    GM1346873Courtesy of GENERAL MOTORS CORP.
  2. Connect the suction port (1).
  3. Connect the secondary level sensor electrical connector.
    4. Fig 2: View Of Fuel Tank Module
    GM1226439Courtesy of GENERAL MOTORS CORP.
  4. Insert the new secondary fuel pump module with the level sender and new fuel pump-to-tank seal. Ensure the orientation tabs are aligned.
  5. Use the J39765-A  to install the fuel pump lock ring. See Special Tools .
  6. Connect the EVAP line quick connect.
  7. Install the fuel tank. Refer to Fuel Tank Replacement (AWD)  or Fuel Tank Replacement (FWD) .
About FixVault