FixVault
Home › Pontiac › 2008 › Torrent Base, FWD › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 3.4L - DTC P0401 To DTC P2544 › DTC P1682 › Circuit/System Testing › Testing the Ignition 1 Signal Circuit

Testing the Ignition 1 Signal Circuit

    IMPORTANT: A resistance of 5 ohms or greater in the circuit will cause the DTC to set.
  1. Ignition ON, verify that B+ is available to both test points of the inline fuse from the ignition main relay to the ECM.
    • If B+ is only available on one test point of the fuse, test the ignition 1 voltage circuit from the fuse to the ECM for a short to ground. If the circuit tests normal, replace the ECM.
    • If B+ is not available on either test point of the fuse, replace the underhood fuse block.
  2. Ignition OFF, disconnect the ECM C1 connector.
  3. Ignition ON, verify that B+ is available at C1-19.
    • If B+ is not available, test the ignition 1 voltage circuit for an open/high resistance condition. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, replace the ECM.
About FixVault