FixVault
Home › Pontiac › 2008 › Vibe Standard › Repair and Diagnosis › External Pages › Different car › Section 245 (Lighting Systems) › Repair Instructions › Daytime Running Lights (DRL) Control Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Caution .
    Fig 1: Identifying Daytime Running Lights (DRL) Control Module Components
    GM2009643Courtesy of GENERAL MOTORS CORP.
  1. Install the DRL control module (1) with the mounting bracket attached to the instrument panel. Secure the bracket with the screw (3).

    Tighten:  Tighten the screw to 8.0 N.m (71 lb in).

  2. Connect the DRL control module electrical connector (2).
  3. Install the instrument panel accessory trim panel. Refer to Instrument Panel Accessory Trim Plate Replacement - Left Side .
About FixVault