FixVault
Home › Pontiac › 2009 › G3 Standard › Repair and Diagnosis › External Pages › Different car › Section 159 (Front Suspension System) › Repair Instructions › Strut Assembly Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Strut Assembly-To-Body & Nut
    GM1241960Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the strut assembly into the vehicle with the strut assembly-to-body nut and tighten to 60 N.m (44 lb ft). Use a wrench in order to hold the piston rod while tightening the nut with the J-42468:  Wrench or equivalent.
  2. Install the strut nut cap, if equipped.
    3. Fig 2: Brake Caliper, Knuckle/Strut Assembly & ABS Speed Sensor Electrical Connector
    GM1241961Courtesy of GENERAL MOTORS CORP.
  3. Install the strut to the knuckle.
  4. Install the nuts and the bolts to the strut and tighten to 100 N.m (74 lb ft).
  5. Install the stabilizer shaft link upper stud to the strut bracket.
  6. Install the stabilizer shaft link upper nut and tighten to 50 N.m (37 lb ft).
  7. Install the brake hose to the strut bracket.
  8. Install the ABS speed sensor wire, if equipped, to the strut bracket.
  9. Install the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. Remove the jack stands and lower the vehicle.
About FixVault