FixVault
Home › Pontiac › 2009 › G6 GT, 2D Convertible, 3.5 K › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.5L - Introduction › Repair Instructions › Ignition Control Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing 4 Screws Securing Ignition Coil And Module Assembly To Bracket
    GM1238999Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil and module assembly to the bracket.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the ignition coil and module assembly screws.

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  3. Connect the spark plug wires as noted during the removal.
  4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  5. Refer to Control Module References for programming and setup information.
About FixVault