FixVault
Home › Pontiac › 2009 › G8 Base › Repair and Diagnosis › Accessories & Equipment › Memory Modules › Configurable Customer Control System › Diagnostic Information and Procedures › DTC B1529 › Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the X3 harness connector at the BCM.
  2. Verify that a test lamp illuminates between the fuse B+ circuit terminal 3 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  3. Ignition OFF, connect the X3 harness connector at the BCM.
  4. Disconnect the harness connector at the turn signal/multifunction switch.
  5. Ignition ON, test for B+ between the B+ circuit terminal 6 and ground.
    • If less than the specified value, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  6. If all circuits test normal, test or replace the turn signal/multifunction switch.
About FixVault