FixVault
Home › Pontiac › 2009 › G8 Base › Repair and Diagnosis › Body & Frame › Door Locks › Theft Deterrent System › Repair Instructions › Theft Deterrent Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: TDM & Steering Column Assembly
    GM1958114Courtesy of GENERAL MOTORS CORP.
    NOTE: Make sure the locating pin on the steering column assembly (2) is aligned with the TDM (1).
  1. Install the TDM (1) to the steering column assembly (2).
    2. Fig 2: Theft Deterrent Module (TDM) Electrical Connector
    GM1958113Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the TDM to steering column assembly retaining screw (3) and tighten to 1 N.m (9 lb in).
    3. NOTE: Rotate the ignition lock cylinder lamp socket counter-clockwise to disengage the locking tangs and pull to detach the ignition lock cylinder lamp socket (2) from the TDM.
  3. Detach the ignition lock cylinder lamp socket (2) from the TDM (1).
  4. Connect the theft deterrent module (TDM) electrical connector (4).
  5. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
  6. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
  8. Program the TDM. Refer to Theft Deterrent Control Module Programming and Setup .
About FixVault