FixVault
Home › Pontiac › 2009 › G8 Base › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.6L - Introduction › Repair Instructions › Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake › Installation Procedure

Installation Procedure

    Fig 1: Identifying CMP Sensor To Engine Front Cover Retaining Bolt
    GM1949769Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor (2) to the engine front cover.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the CMP sensor to engine front cover retaining bolt (1) and tighten to 10 N.m (89 lb in).
    3. Fig 2: Identifying CMP Sensor Electrical Connector
    GM1949767Courtesy of GENERAL MOTORS CORP.
  3. Install the CMP sensor electrical connector (1) to the CMP sensor.
About FixVault