FixVault
Home › Pontiac › 2009 › G8 Base › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.6L - Introduction › Repair Instructions › Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake › Removal Procedure

Removal Procedure

  1. Turn the ignition OFF.
    2. Fig 1: Identifying CMP Sensor Electrical Connector
    GM1949767Courtesy of GENERAL MOTORS CORP.
  2. Remove the camshaft position (CMP) sensor electrical connector (1) from the CMP sensor (2).
    3. Fig 2: Identifying CMP Sensor To Engine Front Cover Retaining Bolt
    GM1949769Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor to engine front cover retaining bolt (1).
  4. Remove the CMP sensor from the engine front cover (2).
About FixVault