FixVault
Home › Pontiac › 2009 › G8 Base › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.6L - Introduction › Repair Instructions › Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake › Removal Procedure

Removal Procedure

  1. Turn the ignition OFF.
    2. NOTE: Do not disconnect the power steering fluid lines/hoses from the reservoir.
  2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Power Steering Fluid Reservoir Replacement (3.6L Engine) .
    3. Fig 1: Identifying CMP Sensor & Electrical Connector
    GM1949776Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft position (CMP) sensor electrical connector (1) from the CMP sensor (2).
    4. Fig 2: Identifying CMP Sensor To Engine Front Cover Retaining Bolt
    GM1949777Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor to engine front cover retaining bolt (1).
  5. Remove the CMP sensor (2) from the engine front cover.
About FixVault