FixVault
Home › Pontiac › 2009 › G8 Base › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.6L - Introduction › Repair Instructions › Knock Sensor Replacement - Bank 1 › Installation Procedure

Installation Procedure

    Fig 1: Identifying Knock Sensor (KS) Electrical Connector & Retaining Bolt
    GM1949898Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the KS (3) to engine block retaining bolt (2) and tighten to 23 N.m (17 lb ft).
    2. Fig 2: Identifying Knock Sensor (KS) Electrical Connector & Retaining Bolt
    GM1949898Courtesy of GENERAL MOTORS CORP.
  2. Install the knock sensor (KS) electrical (1) connector to the KS (2).
  3. Lower the vehicle.
About FixVault