Removal Procedure
- Before you service any fuel system connection, relieve the fuel system pressure Refer to the Fuel Pressure Relief .
- Slide the dust cover from the quick-connect fitting if fitted.
- Disconnect the fuel hose clip verifier from the quick connect fitting.
- Use compressed air in order to blow any dirt from the fitting.
- Choose the correct tool (1) for the size of the fitting from J 37088-A , 7370 or 7371 . Insert the selected tool into the male connector (3), then push inward in order to release the locking tabs.
- Pull the female connector (2) away from the male connector.
- Remove the J 37088-A , 7370 or 7371 from the male connector. See Special Tools .
- Using a clean shop towel, wipe off the male pipe end.
- Inspect both ends of the fitting for dirt and for burrs. Clean or replace the components as required.
WARNING:
Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.
CAUTION:
If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.