FixVault
Home › Pontiac › 2009 › Torrent Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 19 (Battery, Charging System And Starting System) › Repair Instructions › Battery Negative Cable Disconnect/Connect Procedure › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Torrent and 2006 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Ground (Negative) Cable And Bolt
    GM368800Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Clean any existing corrosion from the battery terminal bolt flange and the battery cable end.
  1. Install the battery negative cable to the battery.

    Tighten:  Tighten the battery negative cable terminal bolt to 17 N.m (13 lb ft).

    2. Fig 2: View Of Battery Box Cover
    GM1371149Courtesy of GENERAL MOTORS CORP.
  2. Install battery box cover (1).

    Tighten:  Tighten the battery box cover screws to 2 N.m (18 lb in).

    3. Fig 3: View Of PCM, Bracket & Wire Harness
    GM1371146Courtesy of GENERAL MOTORS CORP.
  3. Install the PCM and bracket to the battery box cover.
  4. Connect the PCM wire harness (2) to the battery box cover.
  5. Program all of the customer's radio station presets and set the radio clock to the current time.
About FixVault