FixVault
Home › Pontiac › 2009 › Vibe GT, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 2.4L (Lax) - Introduction › Repair Instructions › Crankshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Crankshaft Position Sensor O-Ring
    GM2016543Courtesy of GENERAL MOTORS CORP.
  1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
    2. NOTE: Refer to Fastener Caution .
    Fig 2: Identifying Crankshaft Position Sensor, Connector Clamp And Wire Harness
    GM2016540Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not twist the O-ring.
  2. Install the crankshaft position sensor with the bolt.

    Tighten:  9.0 N.m (80 lb in)

  3. Install the wire harness and crankshaft position sensor connector clamp.
  4. Connect the crankshaft position sensor connector.
  5. Install generator assembly.
  6. Install v-ribbed belt.
  7. Install right engine under cover.
  8. Connect cable to negative battery terminal.
  9. Inspect for oil leak.
About FixVault