FixVault
Home › Pontiac › 2009 › Vibe GT, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 2.4L (Lax) - Introduction › Repair Instructions › Crankshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

  1. Disconnect cable from negative battery terminal.
  2. Remove right engine under cover.
  3. Remove v-ribbed belt.
  4. Remove generator assembly.
    5. Fig 1: Identifying Crankshaft Position Sensor, Connector Clamp And Wire Harness
    GM2016540Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the crankshaft position sensor connector.
  6. Separate the crankshaft position sensor connector clamp and wire harness.
  7. Remove the bolt and crankshaft position sensor.
About FixVault