FixVault
Home › Pontiac › 2010 › G6 Base, 2D Coupe › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System & Fuel System - 2.4L - Repair Instructions › Repair Instructions › Camshaft Position Sensor Replacement - Intake › Removal Procedure

Removal Procedure

    Fig 1: Engine Wiring Harness Electrical Connectors
    GM1890093Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connector (7) from the intake camshaft position (CMP) sensor (6).
    3. Fig 2: CMP Sensor & Bolt
    GM1578483Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
About FixVault