FixVault
Home › Pontiac › 2010 › Vibe Base, 1.8 8, Automatic › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System & Fuel System - 1.8L (Lay) - Repair Instructions › Repair Instructions › Camshaft Position Sensor Replacement - Intake › Installation Procedure

Installation Procedure

    Fig 1: Identifying Camshaft Position Sensor O-Ring
    GM2016633Courtesy of GENERAL MOTORS CORP.
  1. Apply a light coat of engine oil to the O-ring (1) on the camshaft position sensors.
    2. Fig 2: View Of Camshaft Position Sensor & Bolt
    GM2016630Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the camshaft position sensor (1) with the bolt and tighten to 10 N.m (7 lb ft).
    3. Fig 3: Locating Camshaft Position Sensor Connector
    GM2016629Courtesy of GENERAL MOTORS CORP.
  3. Connect the camshaft position sensor connector (1).
  4. Inspect for oil leaks.
  5. Install the engine cover. Refer to Engine Cover Replacement .
About FixVault