FixVault
Home › Pontiac › 2010 › Vibe Base, 1.8 8, Automatic › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System & Fuel System - 1.8L (Lay) - Repair Instructions › Repair Instructions › Crankshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying O-Ring & Crank Position Sensor
    GM2016637Courtesy of GENERAL MOTORS CORP.
  1. Apply a light coat of engine oil to the O-ring (1) on the crank position sensor.
    2. Fig 2: Locating Crank Position Sensor Bolt
    GM2016635Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the crank position sensor with the bolt (1) and tighten to 9.0 N.m (80 lb in).
  3. Connect the crank position sensor connector.
  4. Inspect for an oil leak.
  5. Install the right engine under cover.
About FixVault