Removing And Installing Multi-Function Switch: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order.

Put multifunction switch on the selector shaft. The flat point on the serrations in the switch (3) must lie against the flat point on the selector shaft (1).

Fig 1: Putting Multi-Function Switch On Selector Shaft
Courtesy of PORSCHE OF NORTH AMERICA, INC.
NOTE:
- Place multifunction switch on the selector shaft. Do not tilt or use force: you may damage the switch contacts.
Turn switch until the fitting bore (4) can be put on the dowel pin (2) on the transmission housing. See Fig 2 .

Fig 2: Turning Switch Until Fitting Bore Can Be Put On Dowel Pin
Courtesy of PORSCHE OF NORTH AMERICA, INC.