Removing And Installing Multi-Function Switch: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

Hold engine by transport shackle in installed position with special tools 10 - 222A and 9591/1.

Fig 1: Holding Engine By Transport Shackle
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Remove the left catalytic converter.
Detach selector lever cable from deflection lever and transmission support.

Fig 2: Detaching Selector Lever Cable From Deflection Lever
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Place transmission jack under the transmission.
Remove the left transmission support with hydraulic mount.
NOTE:
- The fastening nut M12 (C) must not be loosened. The transmission support will otherwise be damaged.
Fig 3: Loosening Fastening Nut From Left Transmission Support With Hydraulic Mount
Courtesy of PORSCHE OF NORTH AMERICA, INC.
1. A Transmission support
2. B Hydraulic mount
3. C Fastening nut M12
Release and disconnect cable connection to multifunction switch.
Unscrew fastening screws and pull switch off the selector shaft.

Fig 4: Pulling Switch Off Selector Shaft
Courtesy of PORSCHE OF NORTH AMERICA, INC.