Fault code 0096: Diagnosis/troubleshooting

NOTE: Visual inspection: In the next troubleshooting section, please check first that the affected pins on the driver's door control unit plug connection are neither damaged nor corroded. The wiring and plugs of the affected components must also be checked for external damage and proper contact. Repair damaged or corroded pins if possible, otherwise replace affected pins. Repair or replace damaged wires.

NOTE: Sporadic faults: In the event of faults that occur sporadically, the wiring positions that are linked to moving parts on and in the vehicle must be checked for each system. Various statuses that can cause faults must be simulated with the help of the wiring diagram.

NOTE: Battery voltage: A battery voltage of between 11.4 and 14.5 V is required for the following troubleshooting procedure. This must be checked and provided, if necessary. On the vehicle electrical system, the voltage to the fuse (input side) must be guaranteed.

WORK INSTRUCTION CHART

Work instruction			Display OK	If not OK
1	Check driver's door lock (secure actuating element)	Switch off ignition Pull plug C off driver's door control unit Measure resistance between pins 11 and 12 of control unit plug C.	15 to 25 Ω Go to step 4	Go to step 2
2	Check driver's door lock (secure actuating element)	Pull plug A off door lock Measure resistance between pins 1 and 9 of socket A on driver's door lock	15 to 25 Ω Go to step 3	Go to step 5
3	Check line	Measure resistance between control unit plug C, pin 11 and driver's door lock plug A, pin 9	> 5 Ω Go to step 4	Repair line → End
		Measure resistance between control unit plug C, pin 12 and driver's door lock plug A, pin 1	> 5 Ω Go to step 4
		Measure resistance between pins 11 and 12 of control unit plug C	∞ Ω Go to step 4
4	Replace driver's door control unit		→ End
5	Replace driver's door lock		→ End