Fault code 1036: Diagnosis/troubleshooting

NOTE: Visual inspection: In the next troubleshooting section, please check first that the affected pins on the rear left door control unit plug connection are neither damaged nor corroded. The wiring and plugs of the affected components must also be checked for external damage and proper contact. Repair damaged or corroded pins if possible, otherwise replace affected pins. Repair or replace damaged wires.

NOTE: Sporadic faults: In the event of faults that occur sporadically, the wiring positions that are linked to moving parts on and in the vehicle must be checked for each system. Various statuses that can cause faults must be simulated with the help of the wiring diagram.

NOTE: Battery voltage: A battery voltage of between 11.4 and 14.5 V is required for the following troubleshooting procedure. This must be checked and provided, if necessary. On the vehicle electrical system, the voltage to the fuse (input side) must be guaranteed.

NOTE:

Thermal-protection deactivation is a calculated value. This is calculated on the basis of the operating time and load.
The status of the counter can be monitored using the Porsche System Tester 2 No. 9588 in the menu 'Actual values/Thermal protection for power windows'.

NOTE: Before troubleshooting, check the window channels for smooth operation and repair if necessary.

WORK INSTRUCTION CHART

Work instruction			Display OK	If not OK
1	Check thermal protection	Wait at least 45 seconds (without turning off the engine)	Status of the fault changes to sporadic Go to step 2	Go to step 3
2	Power window was actuated too often		→ End
3	Replace rear left door control unit		→ End