Note on adaption
WARNING: This page is about a different car, the 2006 Porsche Cayenne, 2005 Porsche Cayenne, 2004 Porsche Cayenne, and 2003 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
The DME control module must perform a learning and adaptation routine for the throttle valve adjuster if:
- the power supply to the DME control module was interrupted,
- the DME control module connectors were unplugged,
- a new DME control module was installed,
- the throttle valve adjuster was replaced,
- the DME was programmed.
To initiate adaption:
- Switch on the ignition without starting the engine
- Perform a "throttle adaptation" under the "System adaptation" column using the 9588 Porsche System Tester II.
The following conditions must be met, otherwise adaptation is not possible:
- Do not press the accelerator (make sure there is no carpet pressing on the accelerator, for example)
- Stationary vehicle
- Battery positive voltage between 10 V and 16 V
- Engine temperature between 5°C and 100°C
- Intake air temperature > 10°C