Replacing Lid Proximity Sensor Control Unit

NOTIFICATION 

Voltage drop 

• Risk of irreparable damage to control unit 
• Risk of damage to control unit 
• Fault entries in the control unit 
• Programming/coding in the control unit is aborted 
• Malfunctions in control unit, even during programming/coding 
  • Switch off ignition before disconnecting the control unit.
  • Make sure that the power supply is not interrupted during programming/coding.
  • Connect a battery charger with a current rating of at least >Current 90 A  to the vehicle battery.

Information 

The terms "Ignition on" and "Starting engine" are re-defined for fully electric vehicles (battery electric vehicles - BEV).

Establishing operational readiness/Ignition on: 

Prerequisites for establishing operational readiness: High-voltage battery is sufficiently charged, remove vehicle charging cable from the vehicle charge port, put driver's key in the emergency start tray.

Establishing operational readiness automatically: Get into the vehicle and close the driver's door. The driver's key is recognised inside the vehicle. Operational readiness is established.

Establishing operational readiness manually: Press Start/Stop switch. The driver's key is recognised inside the vehicle. Operational readiness is established.

Establishing operational readiness/Starting engine: 

Establish operational readiness and engage transmission range. The vehicle is now ready to drive and can be moved.

Ending operational readiness/Switching off ignition 

Ending operational readiness automatically: Get out of the vehicle with the driver's key and close the driver's door. The driver's key is outside of the vehicle and is no longer recognised by the vehicle. Operational readiness ends.

Ending operational readiness manually: Press Start/Stop switch until the instrument cluster is switched off.

Ending driving readiness/Stopping engine 

Vehicle is stationary: Press the P  button on the instrument cluster. The vehicle is parked.

Information 

The PIWIS Tester  instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms. Different text or additional information may appear on the PIWIS Tester  .

1. Connect the Tester to the vehicle and start it. Establish operational readiness on the vehicle.
2. Place original remote control (hand-held transmitter) in emergency start tray.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Emergency start tray

3. Select the vehicle type if required.
4. Select the Tailgate  control unit in the overview  . PressF12 to continue. The message "Create Vehicle Analysis Log (VAL)?" appears. PressF11 to continue.
5. Coding/programming  must be selected.
6. Automatic coding  must now be selected. PressF12 to continue.
   1. 6.1 The Tester displays the message: Coding was completed successfully.
7. Go back to the overview  .
8. In the overview  , pressF7 to switch to the Additional menu  .
9. Read out all fault memories  , work through faults that are stored if necessary and clear the fault memories.
10. Exit the diagnostic application. End operational readiness on the vehicle. Disconnect the Tester from the vehicle.