FixVault
Home › Saab › 2004 › 9-5 Linear, Automatic › Repair and Diagnosis › Engine Performance › TRIONIC T7 Fuel Control System › Adjustment - Replacement › Crankshaft position sensor › To fit

To fit

  1. Fit the sensor provisionally so that the cable runs along the water pipe. Change the O-ring if necessary and lubricate it with engine oil.
    Fig 1: Illustration For Steps 1 To 3
    G03732757Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. Spray the connector with Kontakt 61 (part no. 30 04 520), press together the connector and fit it in the holder.
  3. Secure the cables with the retaining clip. Take care not to pinch or damage the cables with the clip.
  4. Press in the sensor and screw it on with the O-ring fitted together with the heat shield. Make sure the O-ring is positioned correctly so that the sensor bottoms in the engine block. Otherwise, there is a risk of the sensor mounting lug breaking off.
    Fig 2: Illustration For Steps 4 To 5
    G03732758Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Lubricate the screw for the exhaust manifold heat shield with Molykote 1000 or equivalent (part no. 30 20 271) and fit the heat shield.
  6. Start the engine and check for oil leaks.

    Tightening torque 50 Nm (36 lbf ft) 

About FixVault