Master Cylinder: Installation

Install the master cylinder to body, and connect the clutch pipe to master cylinder.

NOTE: Check that the pipe is routed properly.

Tightening torque:

T1: 15 Nm (1.5 kgf-m, 10.8 ft-lb)

T2: 18 Nm (1.8 kgf-m, 13.3 ft-lb)

Fig 1: Installing Master Cylinder

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Connect the push rod of master cylinder to clutch pedal, and install the clevis pin and snap pin.

NOTE: Apply grease to the clevis pin.

Fig 2: Connecting Push Rod Of Master Cylinder To Clutch Pedal

Courtesy of SAAB-SCANIA OF AMERICA, INC.

After bleeding air from the clutch system, ensure that clutch operates properly.

Install the air intake chamber (Saab 9-2X 2.5i Linear).

Install the intercooler (Saab 9-2X 2.0T Aero).