To fit

When changing hydraulic unit/control module: Make sure the gasket is situated in the groove in the control module.

Fig 1: Installing Gasket In Groove In Control Module
Courtesy of SAAB-SCANIA OF AMERICA, INC.
When changing hydraulic unit/control module: Press the control module in place on the hydraulic unit.
When changing the hydraulic unit/control module: Fit the bolts.
NOTE: Tighten the bolts alternately.

Tightening torque 2.5 Nm (1.8 lbf ft)
If the hydraulic unit is changed: Fit the bracket to the unit.
Tightening torque: 10 Nm (7,5 lbf ft)

Fig 2: Illustration For Step 4
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Put the unit in place with guide pin in the rubber bushing.

Fig 3: Illustration For Steps 5-8
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the bolts and the ground line to the spring strut (on cars with ground cable).
Tightening torque: 25 Nm (18 lbf ft)
Attach the brake pipes to the unit.
Tightening torque: 16 Nm (12 lbf ft)
Plug in the control module.
Refit the battery cover and battery.
Fill with brake fluid and bleed the brake system.
Perform the necessary measures for after reconnecting the battery.