FixVault
Home › Saab › 2005 › 9-7X Arc › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Engine Controls - 4.2L - Introduction) › Repair Instructions › Accelerator Pedal Position (APP) Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Accelerator Pedal Position Sensor
    GM742494Courtesy of GENERAL MOTORS CORP.
  1. Install the APP sensor (2) to vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the APP sensor retaining fasteners (1).

    Tighten:  Tighten the retaining fasteners to 10 N.m (89 lb in).

  3. Connect the APP sensor electrical connector.
About FixVault