FixVault
Home › Saab › 2005 › 9-7X Linear › Repair and Diagnosis › Engine Performance › System › Engine Controls - 4.2L - Introduction › Repair Instructions › Camshaft Position (CMP) Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Locating Camshaft Position Sensor Electrical Connector
    GM487648Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the camshaft position (CMP) sensor.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

  2. Install the CMP sensor electrical connector (1).
About FixVault