FixVault
Home › Saab › 2005 › 9-7X Linear › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Pump Bracket Replacement › Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Power Steering Pump Bracket
    GM1201382Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering pump bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the power steering pump bracket mounting bolts.

    Tighten:  Tighten the power steering pump mounting bolts to 50 N.m (37 lb ft).

  3. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement in Engine Mechanical-4.2L.
  4. Install the power steering pump. Refer to Power Steering Pump Replacement (4.2L)  or Power Steering Pump Replacement (5.3L) .
About FixVault