FixVault
Home › Saab › 2006 › 9-7X 5.3i › Repair and Diagnosis › Body & Frame › Windows › Doors › Repair Instructions › Window Weatherstrip Run Channel Assembly Replacement - Rear › Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Weatherstrip Run Channel (Rear)
    GM690972Courtesy of GENERAL MOTORS CORP.
  1. Install the weatherstrip/run channel to the door.
  2. Press the weatherstrip/run channel into the window frame opening.
  3. Position the tabs on the weatherstrip/run channel into the slots on the door.
  4. Attach the molding to the outside of the door with double sided tape.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the weatherstrip/run channel retaining bolt.

    Tighten:  Tighten the bolt to 10 N.m (88 lb in).

  6. Install the window. Refer to Window Replacement - Rear Door .
  7. Install the water deflector. Refer to Water Deflector Replacement - Rear Door .
  8. Install the outer window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Outer .
  9. Install the inner window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Inner .
  10. Install the trim panel. Refer to Trim Panel Replacement - Side Rear Door .
About FixVault