FixVault
Home › Saab › 2006 › 9-7X 5.3i › Repair and Diagnosis › Steering › Steering Column › Steering Wheel And Column › Repair Instructions › Steering Column Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Steering Column Assembly
    GM731644Courtesy of GENERAL MOTORS CORP.
  1. Install the steering column to the vehicle and connect the column to the intermediate shaft.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the steering column mounting nuts.

    Tighten:  Tighten the nuts to 27 N.m (20 lb ft).

    3. Fig 2: View Of Steering Column & Upper Intermediate Shaft
    GM731631Courtesy of GENERAL MOTORS CORP.
  3. Install the intermediate shaft bolt to the steering column.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

    4. Fig 3: Disconnecting/Reconnecting Steering Column Electrical Connector
    GM731648Courtesy of GENERAL MOTORS CORP.
  4. Connect the body wiring harness connector to the steering column lower bracket.
  5. Connect the steering column electrical connector to the vehicle wiring harness.

    Tighten:  Tighten the screw to 6 N.m (53 lb ft).

  6. Install the knee bolster. Refer to KNEE BOLSTER REPLACEMENT .
  7. Install the steering wheel. Refer to STEERING WHEEL REPLACEMENT .
  8. Unlock the steering column by removing J 42640  from the lower trim cover access hole.
  9. Enable the SIR system. Refer to SIR DISABLING AND ENABLING ZONE 3 .
About FixVault