FixVault
Home › Saab › 2007 › 9-7X 4.2i › Repair and Diagnosis › Body & Frame › Fixed And MOVEABLE Windows › Repair Instructions › Windshield Replacement › Installation Procedure

Installation Procedure

  1. Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
  2. Install the windshield side reveal moldings.
    Fig 1: View Of Window Side Reveal Molding
    GM398501Courtesy of GENERAL MOTORS CORP.
  3. Install the windshield side reveal moldings screws.

    Tighten:  Tighten the windshield side reveal moldings screws to 2 N.m (18 lb in).

    Fig 2: View Of Window Side Reveal Molding Screws
    GM398502Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Reposition the front door sealing weatherstrips (1) to the pinch-weld flange.
    Fig 3: View Of Front Door Sealing Weatherstrip
    GM441415Courtesy of GENERAL MOTORS CORP.
  5. Install the push-pin retainers (2) to the front door sealing weatherstrips located at the base of the windshield pillar.
    Fig 4: View Of Weather-Strip Retainers
    GM588275Courtesy of GENERAL MOTORS CORP.
  6. Install the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  7. Install the windshield wiper arms. Refer to Wiper Arm Replacement .
  8. Install the antenna mast if equipped. Refer to Fixed Antenna Mast Replacement .
  9. Install the rearview mirror. Refer to Rearview Mirror Replacement .
  10. Install the rain sensor. Refer to Windshield Outside Moisture Sensor Replacement .
  11. Close the hood.
  12. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
About FixVault