FixVault
Home › Saab › 2007 › 9-7X 4.2i › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 4.2L - Introduction (2 Of 2) › Repair Instructions › Manifold Absolute Pressure Sensor Replacement › Removal Procedure

Removal Procedure

  1. Turn OFF the ignition.
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
    Fig 1: View Of MAP Sensor Electrical Connector
    GM732831Courtesy of GENERAL MOTORS CORP.
  3. Press the retainer locking tabs inward, then pull the retainer (1) up to remove it.
    Fig 2: View Of MAP Sensor & Retainer
    GM732839Courtesy of GENERAL MOTORS CORP.
  4. Remove the MAP sensor (2).
  5. Inspect the MAP sensor seal for damage, and replace as necessary.
About FixVault