Installation Procedure

Install the steering wheel to the steering wheel shaft.

Fig 1: Steering Wheel & Steering Wheel Shaft
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .
Install the retaining nut that secures the steering wheel to the steering wheel shaft.
Tighten: Tighten the retaining nut to 41 N.m (30 lb ft).
Connect the steering wheel electrical connector.

Fig 2: Steering Wheel Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Install the horn plunger to the steering column.
Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .