FixVault
Home › Saab › 2007 › 9-7X 5.3i › Repair and Diagnosis › Accessories & Equipment › Memory Modules › Secondary And Configurable Customer Controls › Repair Instructions › Steering Wheel Control Switch Assembly Replacement › Installation Procedure

Installation Procedure

  1. Position the steering wheel control switch to the steering wheel.
    Fig 1: View Of Steering Wheel Control Switch Electrical Connector
    GM652807Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the steering wheel control switch.
  3. Install the steering wheel control switch into the steering wheel, ensuring the retaining tabs are fully seated.
  4. Install the shroud to the steering wheel.
    Fig 2: View Of Shroud & Screws
    GM755486Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the shroud retaining screws to the steering wheel.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Install the steering wheel. Refer to Steering Wheel Replacement .
About FixVault