FixVault
Home › Saab › 2007 › 9-7X 5.3i › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 5.3L - Introduction (2 Of 2) › Repair Instructions › Throttle Actuator Control Module Replacement › Removal Procedure

Removal Procedure

  1. Remove the bulk connector from the bracket, insert a small flat-bladed tool to disengage the clip.
    NOTE: Refer to Handling Electrostatic Discharge Sensitive Parts Notice .
    Fig 1: View Of I/P Harness Electrical Connector
    GM899718Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the instrument panel (I/P) harness electrical connector.
  3. Disconnect the engine harness electrical connector.
    Fig 2: View Of Engine Harness Electrical Connector
    GM899719Courtesy of GENERAL MOTORS CORP.
  4. Release the retaining tab on the side of the throttle actuator control (TAC) module (3).
    Fig 3: View Of TAC Module
    GM899720Courtesy of GENERAL MOTORS CORP.
  5. Remove the TAC module (3) from the retaining bracket (1).
  6. If necessary, remove the TAC module bracket nuts (2) and bracket (1).
About FixVault