Circuit/System Testing
IMPORTANT:
The CKP System Variation Learn Procedure may have to be repeated up to 5 times before the procedure is learned.
- Perform the CKP System Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn
- If the CKP System Variation Learn Procedure cannot be performed successfully, inspect for the following conditions:
- Any worn crankshaft main bearings
- A damaged or misaligned reluctor wheel
- Excessive crankshaft runout
- A damaged crankshaft-Refer to Crankshaft and Bearings Cleaning and Inspection .
- Interference in the signal circuit of the CKP sensor
- The ignition switch is left in the ON position, until the battery is discharged
- An ECM power disconnect, with the ignition ON, that may have erased the CKP system variation values and set DTC P0315
- Any debris between the CKP sensor and the reluctor wheel
- If the ECM is unable to complete the learn procedure, replace the ECM.